HVACopedia

Lennox · Air conditioner

E600 Load shed event

Low severity

What the control is telling you

Compressor cycled off by utility load shedding (24 VAC applied across L and C on the outdoor control). Dealer information. S30/S40 thermostat alert code 600 (shown as E600 on the unit control display).

Applies to: Lennox communicating air conditioners incl. variable-capacity inverter units in S30/S40 smart thermostat systems

Likely causes

  • Utility load control signal on L

Test and repair steps

  1. Confirm whether a utility load control device is connected to L.
  2. Clears when L terminal is inactive.

Settings for these units

Save it for the next call

Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.

Open the app

Source: Lennox Residential Communicating Systems Alert Code Guide (V2) 100017 (3/2023), Table 2 Alert Codes and Troubleshooting, p.46. Summarized in our own words; check the original manual for your model.

Homeowner looking at this code? See what it means for you and when to call a technician.

For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.